Leave Your Message

FS-72RGB Colour-coded sensors series

Product Series: Color Mark sensor   NPN: FS-72N      PNP:FS-72P

Built-in RGB three-color light source color mode and color mark mode 

The detection distance is 3 times that of similar color mark sensors

The detection return difference is adjustable, which can eliminate the influence of jitter of

the measured object。

    Product features

     1.Built-in RGB three-color light source color mode and color mark mode
     2.The detection distance is 3 times that of similar color mark sensors
     3.The detection return difference is adjustable, which can eliminate the influence of jitter of the measured object
     4.Light spot size is about 1.5*7mm (23mm detection distance)
     5.Two-point setting method
     6.Smaller size

    Detection distance 18...28mm
    Supply voltage 24VDC±10% Ripple P-P <10%
    Light source Composite LED:Red/Green/Blue(Light source wavelength: 640nm/525nm/470nm)
    Current consumption Power<850mW(Supply voltage is 24V、Consumption current<35mA)
    Output operation Color mark mode: ON when color mark detection; Color mode: ON when consistent
    Protection circuit Short circuit protection
    Response time <200μs
    Ambient temperature -10...55℃(No condensing、   No condensation)
    Environment humidity 35...85%RH(No condensation)
    Housing material Housing: PBT; Operation panel: PC; Operation button: Silica gel; Lens:PC
    Connection method 2m cable(0.2mm² 4-pins cable)
    Weight About 104g

    *Specified measurement conditions: ambient temperature +23℃

     

      

    1

    FAQ

    1. Can this sensor distinguish between two colours, like black and red?
       It can be set to detect black has signal output, red does not output, only for black has signal output, the light is on.

    2. Can the color code sensor locate the black mark on the detection label? Is the response speed fast?
        Aim at the black label you want to identify, press set, and for other colours you don't want to identify, press set again, so that as long as there is a black label passing by, there will be a signal output

    Leave Your Message